Mold can build up in basements and other wet areas causing cause health problems that can be felt immediately or have a long-term effect after excessive water damage. Thus, it becomes important to dry and clean the area as quickly as possible as well as remove unhealthy microorganisms
from the air.
Causes for mold in basement
The problem of mold occurring in a basement is a common one for many homeowners. The basement is the foundation of a house and if this is poorly protected, water can soak up into the concrete, causing cracks and weakening
the home's support. Using a waterproof spray and drainage board can prevent moisture from soaking up into the concrete. Since the basement handles water from roof runoff and drains water from above and below the ground, the problems get reinforced without a proper waterproofing system.
In such cases, the foundation can crack under hydrostatic pressure (the force a standing fluid, such as water, exerts on the foundation walls).
Solution for preventing mold infestation in basement
A proven method of waterproofing the foundation or basement while
also allowing the water to drain away from the home is by applying a waterproof asphalt coating to the foundation walls and by attaching a drainage board to the foundation. The result is two-part system that gives the foundation a strong defense against water problems.
Steps
to a DIY waterproofing to prevent mold in basement
The top of the footing needs a coating of waterproofing spray before the foundation wall is set. This coating prevents water from wicking its way up through the footer and into the home. For this, the foundation walls and
surface needs to be clean, dry and free of debris before the asphalt coating is applied and the plumbing/electrical lines need to be completely sealed prior to spraying evenly and consistently. The final step is to install a proper drain at the side of the footer to drain any bulk water
away from the foundation. The common method for waterproofing foundation walls is to apply a damp-proof coating to the walls. This seals all gaps in the concrete without using a drainage board and although this is a simpler and cheaper method, it does not provide adequate protection
from moisture buildup. As a result, it can lead to leaks, cracks and a buildup of mold. So, it is advisable to go in for the best and most affordable solution as soon as a mold in basement problem is detected to help deter mold while ensuring that the basement stays dry all year long.
Soap Mold
Soap has been made out of wood ashes, animal fat, salt and water and has served cultures the world over for centuries. Soap makers still rely on lye and fat. Soap that is made from saturated fats, which are invariably solid at room temperature, will...
Mold and Mildew
Mold and mildew is a common problem for almost every homeowner at different times during the year, but particularly noticeable during the spring and summer months. Molds that generate mildew thrive wherever it is damp, warm, poorly lighted, and /or...
Mold damage
Molds in any home can cause mild to severe hygiene, sanitation and health problems, apart from also being the primary cause for structural damage. This is because mold can reproduce fast as the mold spores spread in the air and moisture present in...
Types of mold
There are a variety of biological organisms and bioaerosols present in the homes. Mold constitutes a class of microscopic fungi and is just one of these types of microbes that infect households. Mold can thrive in certain indoor conditions conducive...
Mold control
Mold control is a far better option than mold treatment as it consists of simple precautions a homeowner can take to eliminate the possibilities of mold creation, spreading and subsequent damage to home and health. Of primary importance is the...
|
|
